1990 mazda protege manual11/19/2023 Then drive the car the way it is now and enjoy it as you heal.ĭitto. In the long run I am pretty sure you would be better off to just drag your hands over some rough concrete until they bleed, hit a couple fingers with a hammer, pull out the thumbnail on your right hand, and toss $800 into your dispose-all. Hope this helps and doesn't overwhelm you. from the forementioned rare-as-hen's-teeth 5-speed 95-98 Protege ES. The only GUARANTEED way you're going to be able to do this as a "bolt-in" is to get the transmission, axles, clutch mechanism, shifter linkage, etc. you're wandering far into unknown territory on this one. It MIGHT be possible to swap a transmission from another year or model of Protege is you swap the bellhousing too, but I don't know if the input shaft and/or axle splines will be the same. Problem is, that haystack just got bigger. If you intend to do serious power mods, you want that one. If you read the model years carefully, you'll notice that only the 95 Protege ES has the stronger G-type transmission. The only way to tell is to get some parts catalogs and see if the parts numbers are the same. The 6-cyl bellhousings won't fit either.Īn 90-94 Protege, MX-3 4-cyl, or Ford Escort/Mercury Tracer transmission MIGHT fit, but I know that the 95+ Protege has slightly different suspension and axles than all of these cars, and so I don't KNOW if the trannies and axles will fit. The 4-cyl 626, Probe, and other Proteges use either an FS- or ZM-series engine, so the bellhousings won't fit. The only FWD Mazdas to come with the B-series 4-cyl engine were the 90-94 Protege (all), 95-98 Protege ES (and ONLY the ES), MX-3 4-cyl, and the Escort/Tracer. You will need a transmission with the correct bellhousing to fit your engine. Within each family, there are numerous small variations in bellhousings, axle types, etc. G-type "Heavy Duty": MX-6, MX-3 6-cyl, 626, Ford Probe, 90-95 Protege 1.8L DOHC, 90-96 Ford Escort GT/LXe/Mercury Tracer LTS, 01+ Protege 2.0L DOHC OK, since you asked, I'll give you a little more info.įirst, I should explain that Mazda has used 2 basic families of trannies in all of their modern FWD cars:į-type "Light Duty": All Proteges with base engine (90-94 1.8L SOHC, 95-98 1.5L DOHC, 99-01 1.6L DOHC), 323, MX-3 4-cyl, 96-00 Protege 1.8L DOHC I'm not sure but maybe another year transmission would fit or maybe not only the SE's had the 1.8? Any info would be appreciated.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |